Useful Information
43
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message Cause/solution
Base no power
or
No link. Re-connect
base AC adaptor.
L The handset has lost communication with the
base unit. Move closer to the base unit and try
again.
L Unplug the base unit’s AC adaptor to reset the
unit. Reconnect the adaptor and try again.
L The handset’s registration may have been
cancelled. Re-register the handset (page 27).
Busy L The called unit is in use.
L Other units are in use and the system is busy.
Try again later.
L The handset you are using is too far from the
base unit. Move closer and try again.
Call service provider
for your access #
L You have not stored the Voice Mail access
number. Store the number (page 38).
Check tel line L The supplied telephone line cord has not been
connected yet or not connected properly.
Check the connections (page 9).
Error!! L Recording was too short. Try again.
Invalid L There is no handset registered to the base
unit matching the handset number you
entered.
L The handset is not registered to the base unit.
Register the handset (page 27).
Requires subscription
to Caller ID.
L You must subscribe to a Call Display service.
Once you receive caller information after
subscribing to a Call Display service, this
message will not be displayed.
Use rechargeable
battery.
L A wrong type of battery such as Alkaline or
Manganese was inserted. Use only the
rechargeable Ni-MH batteries noted on page
4, 7.
TG403xC(e).book Page 43 Wednesday, January 13, 2010 1:44 PM
To Next Page
Loading...
