Panasonic KX-TG5433

Answering System Features
For assistance, please call 1-800-211-PANA (7262). 53
Caller’s recording time
You can change the maximum message
recording time allotted to each caller.
“1min”, “2min”, or “3min” (default): Caller
messages are limited to 1 minute to 3
minutes.
“Greeting only”: The unit plays the
greeting message but does not record
caller messages.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set answering” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Recording time” by
pressing {V} or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
L You can also select the recording
time by pressing {1} to {3}, or {0}
(“Greeting only”).
6 Press {Save}, then press {OFF}.
Note:
L If message memory becomes full, the
unit will automatically switch to the
“Greeting only” mode.
Message alert
You can select whether or not the
message indicator on the handset will
flash when new messages have been
recorded (page 47). The default setting is
OFF.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Message alert” by pressing
{V} or {^}, then press {>}.
4 Press {V} or {^} repeatedly to select
“On” or “Off”.
5 Press {Save}, then press {OFF}.
Note:
L The message indicator will not flash for
new messages while the handset is in
use.
L While message alert is on, battery
operating time will be shortened (page
12).
TG5431_5432_5433(e).book Page 53 Friday, January 14, 2005 4:11 PM