Useful Information
60 For assistance, please call 1-800-211-PANA (7262).
Making/answering calls, Intercom
Problem Cause & solution
Static is heard, sound
cuts in and out.
Interference from other
electrical units.
L Move the handset and the base unit away from other
electrical appliances.
L Move closer to the base unit.
L Raise the base unit antennas.
L Turn on the clarity booster feature (page 20).
L If your unit is connected to a telephone line with xDSL
service, we recommend connecting a noise filter
between the base unit and the telephone line jack.
Contact your xDSL provider for details.
The handset does not
ring.
L The ringer volume is turned off. Adjust it (page 37).
I cannot make a call. L The dialing mode may be set incorrectly. Set the dial
mode (page 40) to match the type of telephone service
you have (tone or pulse).
L If the base unit (including answering system) or another
handset is in use, you may not be able to make a call.
Try again later.
L While listening to messages using the handset, you
cannot make a call. Exit by pressing {OFF}.
I cannot redial by
pressing {REDIAL}.
L If the last number dialed was more than 48 digits long,
the number will not be redialed correctly.
L If you press {REDIAL} after you have started dialing,
this button functions as the {PAUSE} button. To redial,
do not dial any numbers before pressing {REDIAL}.
I cannot have a
conversation using the
headset.
L Make sure that an optional headset is connected
properly (page 57).
L If “SP-phone” is displayed on the handset, press {C}
to switch to the headset.
I cannot make long
distance calls.
L Make sure that you have long distance service.
I cannot page the
handset or base unit.
L The called handset is too far from the base unit.
L The called unit is in use. Try again later.
TG5431_5432_5433(e).book Page 60 Friday, January 14, 2005 4:11 PM
To Next Page
Loading...
