Programming
31
KX-TG6031/KX-TG6032/KX-TG6033/KX-TG6034/KX-TG6051/KX-TG6052/
KX-TG6053 only
*1 If “System setting” column is checked, you do not need to program the same item
using another handset.
*2 If you subscribe to Call Display service and want to view the caller’s information
after lifting up the handset to answer a call, turn off this feature.
*3 Turn this feature off if you prefer not to hear key tones while you are dialing or
pressing any keys, including confirmation tones and error tones.
*4 If you subscribe to a distinctive ring service, select a tone (tone 1 to 3). If you
select a melody, you cannot distinguish lines by their ringers.
*5 The flash time depends on your telephone exchange or host PBX. Consult your
PBX supplier if necessary.
*6 Generally, the line mode setting should not be adjusted. If “Line in use” is not
displayed when another phone connected to the same line is in use, you need to
change the line mode to “A”.
*7 This feature allows the unit to automatically adjust the date and time setting when
caller information is received. To use this feature, set the date and time first.
*8 KX-TG6051/KX-TG6052/KX-TG6053
Feature Feature
code
Setting code System
setting
*1
Page
Display
(Change language)
{0}{8}{1}{1}: <English>
{2}: Français
–15
Message play {2} ––35
Recording time {0}{6}{2}{1}: 1min {2}: 2min
{3}: <3min>
r 38
Remote code {0}{6}{3} Default: 11 r 37
Ring count {0}{6}{1}{2}–{7}: 2–7 rings <4>
{0}: Toll saver
r 37
Ringer tone
(Base unit)
{0}{*}{1}{1}–{3}: Tone <1>–3 r –
Talking
CallerID
*8
(Handset)
{9}{1}: <On> {0}: Off –23
Talking
CallerID
*8
(Base unit)
{0}{*}{4}{1}: <On> {0}: Off r 23
Voice prompt
(Change language)
{0}{8}{2}{1}: <English>
{2}: Français
r 15
TG602X_603X_605XC(e).book Page 31 Tuesday, December 26, 2006 1:55 PM
To Next Page
Loading...
