Useful Information
47
Programmable settings
Battery recharge
Problem Cause/solution
I cannot program items. L Programming is not possible while either the
base unit or another handset is being used. Try
again later.
I cannot set the alarm. L In order to set the alarm, you must first set the
date and time (page 15).
LThe handset has lost communication with the
base unit. Move closer to the base unit, and try
again.
While programming, the
handset starts to ring.
LA call is being received. Answer the call and
start again after hanging up.
Problem Cause/solution
I fully charged the battery,
but 7 continues to flash,
or 8 is displayed.
LClean the charge contacts and charge again
(page 12).
LThe battery may need to be replaced with a new
one (page 11).
The handset display is
blank.
LConfirm that the battery is properly installed.
LFully charge the battery (page 11).
While charging, the charge
indicator does not light and
“Charge for 7h” is
displayed.
LThe battery is empty. The charge indicator does
not light in order to concentrate on charging.
After about 5 minutes, the charge indicator lights
and “Charging” is displayed.
TG602X_603X_605XC(e).book Page 47 Tuesday, December 26, 2006 1:55 PM
To Next Page
Loading...
