Initial settings
n Direct command code:
Programmable settings can be
accessed by pressing MMENUN, #
and then the corresponding code
on the dial keypad (page 23).
Example:
Press MMENUN#101.
n Symbol meaning:
Example: MbN: “ Off ”
Press MCN or MDN to select the
words in quotations.
Important:
R When you install the batteries for the
first time, the handset may prompt
you to set display language and date
and time.
Perform step 2 in “Display
language”, page 13, and then
press MSELECTN.
Continue from step 2 in “Date and
time”, page 13.
Display language
You can select either “English” or
“Français” as the display language.
The default setting is “English”.
1 MMENUN#110
2 MbN: Select the desired setting. a
MSAVEN
3 MOFFN
Date and time
1 MMENUN#101
2 Enter the current month, date, and
year by selecting 2 digits for each.
Example: July 15, 2011
07 15 11
3 MOKN
4 Enter the current hour and minute
(12-hour clock format) by selecting 2
digits for each.
Example: 9:30
09 30
5 MAM/PMN: Select “AM” or “PM”.
6 MSAVEN a MOFFN
Note:
R When English is selected as the
display language, 12-hour clock
format is used. When French is
selected, 24-hour clock format is used.
R The date and time may be incorrect
after a power failure. In this case, set
the date and time again.
Voice guidance language
You can select either “English” or
“Français” as the voice guidance
language of the answering system. The
default setting is “English”.
1 MMENUN#112
2 MbN: Select the desired setting.
3 MSAVEN a MOFFN
Dialing mode
If you cannot make calls, change this
setting according to your telephone line
service. The default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
1 MMENUN#120
2 MbN: Select the desired setting.
3 MSAVEN a MOFFN
13
Getting Started
To Next Page
Loading...
