– 3 –
Link to cell
You can use the unit to make or answer calls using a cellular line. Your cellular
phones must be Bluetooth
®
wireless technology compatible with this product. For
more details, please visit our Web site: http://www.panasonic.com/link2cell
LLocate your cellular phone near the base unit. If the cellular phone is too close to
the base unit during a cellular call, you may hear noise. For best performance, we
recommend placing the cellular phone between 0.6 m to 3 m (2 feet to 10 feet)
away from the base unit.
Registering a Bluetooth cellular phone
1 Handset:
For CELL 1: {MENU} (6241
For CELL 2: {MENU} (6242
LAfter the CELL 1 or CELL 2 indicator on the base unit starts flashing red, the rest
of the procedure must be completed within 5 minutes.
2 Your cellular phone:
While the CELL 1 or CELL 2 indicator is flashing red, follow the instructions of your
cellular phone to enter the registration mode.
LDepending on your cellular phone, it may ask you to enter the base unit PIN
(default: “0000”).
3 Handset:
Wait until a long beep sounds.
LIt may take more than 10 seconds to complete registration.
LWhen the CELL 1 or CELL 2 indicator lights green, the cellular phone is
connected to the base unit. You are ready to make cellular calls.
4 To select which unit receives calls for the cellular line (default: “All”):
{OK} s {r}: Select the desired handset or “All”. s {SAVE}
LIf not required, go to step 5.
5 {OFF}
Note:
LMake sure that your cellular phone is set to connect to this product automatically.
Refer to your cellular phone’s operating instructions.
Trademarks
LThe Bluetooth
®
word mark and logos are owned by the Bluetooth SIG, Inc. and any
use of such marks by Panasonic Corporation is under license. All other trademarks
identified herein are the property of their respective owners.
Cellular line
service provide
To Next Page
Loading...
