8.1.2. Handset
Important:
Make sure the address on LCD is correct when entering new data. Otherwise, you may ruin the unit.
9).
Press (off) to return to standby mode.
After that, turn the base unit power off and then power on.
1). Press {}
2). Select "Initial Setup" using or
then press
{OK} .
H/S key operation
{^} {V}
3). Enter "7", "2", "6", "2", "7", "6", "6", "4".
Note: 7262 7664 = PANA SONI
(see letters printed on dial keys)
6). Enter " ", " ", " ", " " (Address). (*1)
7). Enter "
", " " (New Data). (*1)
4). Select "Write EEP" using or
then press or
{>}.
{^} {V}
_ _ _ _ _ _
H/S LCD
Set Addr.:
Default Data
Set Addr.:
C
OK
New Data
Set Addr.:
C
OK
8). Press , a long confirmation beep
will be heard.
{OK}
OK
Service Mode
Read EEP
Write EEP
{OK}
/ECO
Dial keypad
{TALK:Talk }{}
{
}
{}
Soft keys
(Volume) key/
(Phonebook)/
q (Caller list) key/
R (Redial) key/
Navigator key/
(Off/Power)
R
R
: Recall/Flash
ECO: Eco mode shortcut key
To Next Page
Loading...
