Using the call block button
You
can press the M
N in the following situation to
di
sconnect the current call and add a phone
number to the call block list:
– when an incoming call is being received
– when an incoming call is being recorded by the
answering system
– when talking on an outside call on the base unit
Once a phone number has been added to the call
block list, the unit will block calls from that phone
number in the future.
Handset / Base unit
1 Pre
ss M
N under the situations shown above.
2 Co
nfirm the call block number and press MOKN.
R The call block number is stored in the call
block list, “Caller Blocked” is displayed,
and then the call is disconnected.
Note:
R If the call has no phone number, the call is
blocked but it is not stored in the call block list.
R The call block feature is not available for the
calls during call waiting or intercom call.
R Blocked calls are logged in the caller list.
Storing unwanted callers
The unit can block calls by storing the desired
items into the call block list beforehand (Caller ID
subscribers only).
– “Single Number”: The unit blocks calls from
specific phone numbers stored in the call block
list.
– “Range of Numbers”: The unit blocks calls
that begin with a number stored in the call block
list, such as a toll-free phone number prefix or
certain area codes.
– “Withheld”: The unit blocks calls that have no
phone number.
Single phone numbers and ranges of numbers can
be stored in the call block list up to 100 items in
total.
Blocking unwanted callers:
When a call is received, the unit does not ring
while the caller is being identified.
If the caller’s phone number matches an entry in
the call block list, the unit emits no sound to the
caller, and disconnects the call.
Storing a single phone number
I
m
p
ortant:
R You must include the area code when storing
phone numbers in the call block list.
Adding call blocked numbers from the caller
lis
t
Handset
1 M N
2 MbN: Select the entry to be blocked. a M N
3 MbN: “Sa
ve Caller ID” a MOKN
4 MbN: “Nuisance Call Block” a MOKN
5 MbN: “Yes” a MOKN a M
N
Base unit
1 M N
2 MbN: Select the entry to be blocked.
3 M N
4 MbN: “Ye
s” a MOKN a M
N
Adding call blocked numbers manually
Handset
1 M N#217
2 MbN:
“S
i
ngle Number” a MOKN
3 M
N a MbN: “Ad
d” a MOKN
4 Enter the phone number (24 digits max.).
5 MOKN a M
N
Base unit
1 M N
2 MbN: “Si
ngle Number” a MOKN a M
N
3 Ent
er the phone number (24 digits max.).
4 MOKN a M
N
Storing a range of number
Handset
1 M N#217
2 MbN: “Ra
nge of Numbers” a MOKN
3 M
N a MbN: “Add” a MOKN
4 Enter the desired number (2-8 digits).
5 MOKN a M N
21
Nuisance Call Block
To Next Page
Loading...
