Changing the start and end time
Handset / Base unit
1 M N#237
2 Con
tinue from step 3, “Turning do not disturb
mode on/off”, page 33.
Setting the ring delay
Thi
s setting allows the handset to ring during do
not disturb mode if the caller waits long enough.
After the selected amount of time passes, the
handset rings. If you select “No Ringing”, the
handset never rings during do not disturb mode.
Handset / Base unit
1 M N#239
2 MbN: S
elect the desired setting. a MOKN
3 Proceed with the operation for your unit.
Handset: M
N
Bas
e unit: M
N
N
o
t
e:
R When the answering system answers the call,
this feature does not work. (KX-TGF320 series:
page 3)
Selecting categories to bypass do not disturb
mode
Handset / Base unit
1 M N#241
2 MbN: S
elect the desired category. a M
N
R “ ” is displayed next to the selected
cat
egory numbers.
R To cancel the selected category: MbN: Select
the category. a Press M
N again. “ ”
dis
appears.
3 MOKN
4 Proceed with the operation for your unit.
Handset: M
N
Bas
e unit: M
N
Baby monitor
Thi
s feature allows you to listen in on a room
where the handset is located, allowing you to
easily monitor from different areas of the house or
place. The monitored handset (placed in a baby’s
room, for example) will automatically call the base
unit or the phone number stored when it detects
sou
nd.
Important:
R You should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For example,
test its sensitivity. Check the connection if you
are diverting the baby monitor to an outside line.
R This feature should not be used as a substitute
for a medical or caregiver’s supervision. It is the
caregiver’s responsibility to stay close enough
to handle any eventuality.
Note:
R If the unit is connected to a PBX system, you
cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset on
the charger.
R The monitored handset never rings while it is
being monitored.
If the base unit is placed near the monitored
handset, turn off the base unit ringer volume
(page 29).
Setting the baby monitor
Perform the setting operation with the handset to
be monitored (for example, the handset placed in
a baby’s room).
To monitor with the base unit
The
internal baby monitor feature is available
between the handset and the base unit.
Handset
1 M N#268
2 MbN: “On” a MOKN
3 MbN: Select “Base” to monitor with. a MOKN
R “Baby Monitor” will be displayed.
R The registered unit’s name is displayed.
Note:
R When this feature is on, the base unit can hear
the monitored handset by making an intercom
call.
To monitor from an outside line
If
you enable this feature, the unit will call a
pre-programmed phone number when the handset
34
Programming
To Next Page
Loading...
