Other settings
Eco mode setting
Handset
You
can select the desired eco mode setting by
pressing MECON.
The following settings are available for eco mode.
– “Eco”: Reduces the base unit transmission
power by up to 90 % in standby mode.
When this setting is selected,
i
s displayed.
*
1
– “E
co Off” (default setting): Turns off eco
mode.
When this setting is selected,
is not
dis
played.
*1
Handset:
is displayed instead of .
Not
e:
R When there is another cordless phone in use
nearby, the base unit transmission power may
not be reduced.
R When eco mode is active, the range of the base
unit is reduced in standby mode.
R If you set repeater mode to “On” (page 37):
– Eco mode is disabled.
– “Eco Mode” is not displayed in the display
menu (page 30).
Dialling mode
If
you cannot make calls, change this setting
according to your telephone line service. The
default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
You can configure this setting using either the
base unit or the handset.
Handset / Base unit
1 M N#120
2 MbN:
S
elect the desired setting. a MOKN
3 Proceed with the operation for your unit.
Handset: M
N
Bas
e unit: M
N
15
Getting Started
To Next Page
Loading...
