Error messages
Display message Cause/solution
Base no power
or
No
link.
Reconnect
AC adaptor.
R C
onfirm the base unit’s AC adaptor is connected to the unit and
t
h
e power outlet correctly.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset’s registration may have been cancelled. Re-register
the handset (page 53).
Check
Pho
ne Line
R The supplied telephone line cord has not been connected yet or
no
t connected properly. Check the connections (page 8).
Error
R Recording was too short. Try again.
Me
mory Full
R The phonebook memory is full. Erase unwanted entries (page 24).
R Th
e call block list memory is full. Erase unwanted entries
(page 22).
Use
rec
hargeable
battery.
R A
wrong type of battery such as alkaline or manganese was
i
n
serted. Use only the rechargeable Ni-MH batteries noted on
page 4, 6.
You must first
sub
scribe
to Caller ID.
R Y
ou must subscribe to a Caller ID service. Once you receive
c
a
ller information after subscribing to a Caller ID service, this
message will not be displayed.
Troubleshooting
I
f
you still have difficulties after following the instructions in this section, disconnect the base unit’s AC
adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset, and then
insert them into the handset again.
If the base unit batteries for power backup are installed, remove the batteries from the base unit, and
then insert them into the base unit again.
General use
Problem Cause/solution
The handset does not turn on
e
v
e
n after installing charged
batteries.
R Place the handset on the charger to turn on the handset.
The unit does not work. R Make sure the batteries are installed correctly (page 8).
R Fu
lly charge the batteries (page 9).
R Check the connections (page 8).
R Unplug the base unit’s AC adaptor and remove the batteries from
the handset to reset the unit. Reconnect the adaptor, insert the
batteries into the handset and try again.
R The handset has not been registered to the base unit. Register
the handset (page 53).
The handset display is blank. R The handset is not turned on. Turn the power on (page 14).
50
Useful Information
To Next Page
Loading...
