Panasonic KX-TGF310CX - Handset Battery Charging; Base Unit Battery Installation

Handset battery charging
C
h
a
rge for about 7 hours.
R Confirm “Charging” is displayed (
1
).
R Whe
n the batteries are fully charged, “Fully
Charged” is displayed.
1
Handset battery level
Icon Battery level
High
Medium
Low
Needs charging.
Panasonic Ni-MH battery performance
(su
pplied batteries)
Operation Operating time
In continuous use 17 hours max.
Not in use (standby) 330 hours max.
Note:
R Act
ual battery performance depends on usage
and ambient environment.
Base unit battery installation (for
pow
er backup)
You can insert 2 AAA (R03) batteries (not
supplied) into the base unit that will power the unit
temporarily in the event of a power failure.
Important:
R The following batteries can be used with the
base unit:
– Rechargeable Ni-MH batteries
*1, *2
(including
the batteries used in your handset(s))
– Standard (non-rechargeable) alkaline
batteries
*3
R Do NOT use manganese batteries.
R Confirm correct polarities ( , ).
*1 T
he base unit can fully charge Ni-MH batteries
in about 15 hours.
*2 We recommend using Panasonic
rechargeable batteries (page 4).
*3 Only insert alkaline batteries once a power
failure occurs. Remove the alkaline batteries
when power is restored.
1 Disconnect the telephone line cord (A).
2 Open the battery cover (B).
3 Install the batteries in the battery compartment
(C).
4 Close the cover, then reconnect the telephone
line cord (D).
B
C
D
A
Note:
R If
your phone service provider requires
additional devices in order to make and receive
calls, such as a modem, you may still not be
able to make and receive calls even if the base
unit’s backup power feature is functioning.
Base unit battery status when a power failure
occ
urs
Icon Battery status
Power backup mode is on.
Battery power is low.
*1
*1
If
begins flashing on the base unit, replace
the
batteries with new ones as soon as
possible. If you replace Ni-MH batteries with
9
Getting Started
KX-TGF310_320CX(en)_0429_OI.pdf 9 4/29/2015 4:08:39 PM