R When enhanced security is enabled, sound may
cu
t in and out during conversations.
Changing the base unit PIN
Important:
R If you change the PIN (Personal Identification
Number), please make note of your new PIN.
The unit will not reveal the PIN to you. If you
forget your PIN, contact an authorised service
centre.
Handset / Base unit
1 M N#132
2 E
n
t
er the current 4-digit base unit PIN (default:
“0000”).
3 Enter the new 4-digit base unit PIN. a MOKN
4 MbN: “Yes” a MOKN
5 Proceed with the operation for your unit.
Handset: M
N
Bas
e unit: M
N
Increasing the range of the base unit
You
can increase the signal range of the base unit
by using a DECT repeater. Please use only the
Panasonic DECT repeater noted on page 4.
Contact your Panasonic dealer for details.
Important:
R Before registering the repeater to this base unit,
you must turn the repeater mode on.
R Do not use more than one repeater at a time.
Setting the repeater mode
Handset / Base unit
1 M N#138
2 MbN: S
elect the desired setting. a MOKN
3 Proceed with the operation for your unit.
Handset: M
N
Bas
e unit: M
N
Registering the DECT repeater (KX-A405/
KX-
A406) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the DECT
rep
eater.
1 Base unit:
Press and hold M
N
for about 5 seconds.
2 D
E
CT repeater:
Connect the AC adaptor, then wait until the
indicator and indicator light green.
3 Bas
e unit:
To exit the registration mode, press M
N.
37
Programming
To Next Page
Loading...
