detects sound. After you answer the call, you can
lis
ten in on the room where the handset is located.
n From the phonebook:
1 M
N#268
2 MbN: “On” a MO
KN
3 MbN: Select “External” to monitor from an
outside line. a M
N a M N
4 MbN: “Ph
onebook” a MOKN
5 MbN: Select the phonebook entry. a MOKN
R “Baby Monitor” will be displayed.
Note:
R If you edit a phonebook entry which is
assigned for monitoring, the edited entry does
not transfer to the monitor.
n By entering phone numbers:
1 M
N#268
2 MbN: “On” a MO
KN
3 MbN: Select “External” to monitor from an
outside line. a M
N a M N
4 MbN: “Ma
nual” a MOKN
5 Enter the desired name. a MOKN
6 Enter the desired number. a MOKN 2 times
R “Baby Monitor” will be displayed.
Note:
R The registered name/number is displayed.
Turning off the baby monitor
The monitored handset cannot be used while baby
monitor is set to “On”.
Handset
1 Pre
ss M
N on the handset being monitored.
2 MbN: “O
n/Off” a MOKN
3 MbN: “Off” a MOKN a M
N
Editing an outside monitoring number
Handset
1 Pre
ss M
N on the handset being monitored.
2 MbN: “O
n/Off” a MOKN
3 MbN: “On” a MOKN
4 MbN: Select the outside line. a M
N
5 M N a MbN: “Ed
it” a MOKN
6 Edit the name if necessary. a MOKN
7 Edit the phone number if necessary. a MOKN
2
times
Erasing an outside monitoring number
Handset
1 Pre
ss M
N
on the handset being monitored.
2 MbN:
“O
n/Off” a MOKN
3 MbN: “On” a MOKN
4 MbN: Select the outside line. a M
N
5 M N a MbN: “Erase” a MOKN
6 MbN: “Yes” a MOKN a M N
Baby monitor sensitivity
You
can adjust the sensitivity of the baby monitor.
Increase or decrease the sensitivity to adjust the
sound level needed to trigger the baby monitor
feature.
R This feature cannot be set during a monitoring
call.
Handset
1 Pre
ss M
N on the handset being monitored.
2 MbN: “S
ensitivity Level” a MOKN
3 MbN: Select the desired setting. a MOKN a
M
N
Answering the baby monitor
n When monitoring with the base unit:
Press MZN to answer a call.
If you want to respond from the monitoring unit,
press M N.
R The
monitoring unit will answer calls
automatically when the auto intercom feature
is set to “On” (page 19).
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
To answer the call, press MZN 3 times.
*1
*1 If M
N is pressed, press M N 2 times.
n When monitoring from an outside line:
Answer the call.
If you want to respond from the monitoring
phone, press #1 using tone dialling.
You can turn off the baby monitor feature by
pressing #0.
35
Programming
To Next Page
Loading...
