5. Connect the port cables.
6. Confirm that the RUN indicator blinks the same number of times as the Mode Switch position (e.g., 5 blinks
for switch position 5, etc.).
• This may take several minutes. The ALARM indicator and RUN indicator will first blink intermittently
before the RUN indicator blinks to indicate the Mode Switch position.
7. Turn the power switch off at the VPS.
8. Set the Mode Switch to position 0.
9. Turn the power switch back on at the VPS.
42 Installation Manual Document Version 3.0 2010/06
2.3 Names and Locations
To Next Page
Loading...
