2.5 System Parameters
130 Programming Manual
Call Transfer to Outside Reconnect Sequence on Busy
Specifies the sequence the VPS uses to reconnect the line when the transferred party is busy.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause for 1 s (default)
;: Dial Pause for 3 s (default)
N: Telephone Number Dialling
0–9, , #: Dial Codes
Feature Manual References
2.2.7 Call Transfer to Outside
Call Transfer to Outside Reconnect Sequence on No Answer
Specifies the sequence the VPS uses to reconnect the line when the transferred party does not
answer.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause for 1 s (default)
;: Dial Pause for 3 s (default)
N: Telephone Number Dialling
0–9, , #: Dial Codes
Feature Manual References
2.2.7 Call Transfer to Outside
EFA Transfer Sequence
Specifies the sequence the VPS uses to transfer calls to Trunks using EFA (External Feature Access).
This setting should match the setting of the PBX.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
To Next Page
Loading...
