2.5 System Parameters
Programming Manual 131
T: Dial Tone Detection
,: Dial Pause for 1 s (default)
;: Dial Pause for 3 s (default)
N: Telephone Number Dialling
0–9, , #: Dial Codes
EFA Transfer Reconnect Sequence on Busy
Specifies the sequence the VPS uses to reconnect the line when the party transferred with EFA
(External Feature Access) is busy. This setting should match the settings of the PBX.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause for 1 s (default)
;: Dial Pause for 3 s (default)
N: Telephone Number Dialling
0–9, , #: Dial Codes
EFA Transfer Reconnect Sequence on No Answer
Specifies the sequence the VPS uses to reconnect the line when the party transferred with EFA
(External Feature Access) does not answer. This setting should match the settings of the PBX.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause for 1 s (default)
;: Dial Pause for 3 s (default)
N: Telephone Number Dialling
0–9, , #: Dial Codes
Call Transfer to Outside Answer Mode
Specifies the answering method the VPS uses to detect whether the destination party has answered
the transferred CO call.
Value Range
Analyse: the VPS monitors the status of the Trunk, recognises that the destination party goes off-
hook, and connects the line.
To Next Page
Loading...
