Panasonic KX-TVM50 - Installing Port Cards in the KX-TVM200

2.6 Installing Port Cards in the KX-TVM200
1. Position the front of the card so that the jacks fit in the open slot. Make sure that the tabs on both sides of
the card fit into place. Holding the card firmly in place, lower the other end of the card so that the card’s
hole fits over the extension bolt.
CAUTION
When installing optional cards, do not put pressure on the main board. Doing so may result in damage
to the VPS.
Extension Bolt
1
2
Document Version 2.1 2008/04 Getting Started 13
2.6 Installing Port Cards in the KX-TVM200