2.16 Wall Mounting
2.16.1 Wall Mounting the VPS
Mounting on a Wooden Wall
1. Place the appropriate wall mounting template (found on the last 2 pages of this manual) on the wall to mark
the locations where the 3 screws need to be placed.
2. Install the screws and washers (included) in the wall.
Note
• Drive the screws into the wall until each screw head is the same distance from the wall.
• Install the screws perpendicular to the wall.
3. Mount the unit as shown.
Note
• Do not block the openings of the unit. Allow space of at least 20 cm above and 10 cm on the sides
of the unit.
• Make sure that the wall behind the unit is flat and free of obstructions so that the openings on the
back of the unit will not be blocked.
• Be careful not to drop the unit.
Mounting on a Concrete or Mortar Wall
CAUTION
When driving the mounting screws into the wall, be careful to avoid touching any metalwork (metal/wire
laths, etc.), conduits, or electrical cables buried in the wall.
Document Version 2.1 2008/04 Getting Started 27
2.16.1 Wall Mounting the VPS
To Next Page
Loading...
