2 Installation
2.1 Installation Overview
The following is an overview of the steps needed to prepare the VPS hardware for use. Refer to the Installation
Manual when installing optional cards or hardware.
CAUTION
The information below is only intended as an overview of the installation process. When installing the VPS,
refer to the information provided in this document or to the Installation Manual for detailed instructions.
1. Remove the cable cover.
2. KX-TVM200 only: Install the port cards.
3. Connect the VPS to the appropriate extension ports of the PBX.
4. Connect the VPS to the PC to be used for programming.
5. Connect the VPS to earth.
6. Connect the AC adaptor to the VPS and to the power outlet.
7. Secure the cables.
8. Initialise the VPS.
9. Attach the cable cover.
10. Wall mount the VPS and AC adaptor.
6 Getting Started Document Version 2.1 2008/04
2.1 Installation Overview
To Next Page
Loading...
