Panasonic KX-TVM50 - Wall Mounting the AC Adaptor

1. Place the appropriate wall mounting template (found on the last 2 pages of this manual) on the wall to mark
the locations where the 3 screws need to be placed.
2. Install 3 anchor plugs (user-supplied) in the wall, then install the screws (included) in the wall.
Hammer
29 mm
Anchor Plug
6.4 mm
Drive the screw
to this position.
3. Mount the unit as shown.
Note
• Do not block the openings of the unit. Allow space of at least 20 cm above and 10 cm on the sides
of the unit.
• Make sure that the wall behind the unit is flat and free of obstructions so that the openings on the
back of the unit will not be blocked.
• Be careful not to drop the unit.
2.16.2 Wall Mounting the AC Adaptor
Mounting on Wooden Wall
1. Place the AC adaptor wall mounting template (found later in this section) on the wall to mark the locations
where the 2 screws need to be placed.
2. Install the screws and washers (included) in the wall.
Washer
Drive the screw
to this position.
28 Getting Started Document Version 2.1 2008/04
2.16.2 Wall Mounting the AC Adaptor