4.5 E-mail Integration Settings
The VPS can be programmed to send text and voice messages (as file attachments) to subscribers when they
have new messages. The following settings must be made in order for the VPS to use E-mail Integration
features. Consult the LAN administrator for the appropriate settings.
System Settings for E-mail Integration
1. Start KX-TVM Maintenance Console and connect to the VPS.
2. Click System Parameters (under Shortcuts), then click the Parameters tab.
3. Set E-mail Integration to Enable.
4. Enter an e-mail address next to Mail Address.
Note
• We recommend entering an administrator’s e-mail address here. If there are any errors when the
VPS tries to send e-mail messages, error messages will be sent to this address.
5. Enter the name that will appear in e-mail messages sent from the VPS next to Full Name. This name
should indicate that the message came from the VPS.
6. Enter the IP address or host name of the outgoing mail server next to SMTP Server Address.
Note
• If authentication is required when accessing the outgoing mail server (SMTP server), make the
appropriate settings under Advanced Settings.
Document Version 2.1 2008/04 Getting Started 49
4.5 E-mail Integration Settings
To Next Page
Loading...
