2.3 Opening the Front Cover
The model shown here is the KX-TVM200, however this procedure is the same for the KX-TVM50.
For KX-TVM50:
This procedure is not necessary if you do not plan on installing optional cards in the KX-TVM50.
1. Remove the 3 screws.
2. While holding both tabs located on the sides of the front cover, swing the cover open as shown.
3. To remove the front cover completely during installation, hold the front cover open at a 45° angle, then lift
the cover away from the unit as shown.
8 Getting Started Document Version 2.1 2008/04
2.3 Opening the Front Cover
To Next Page
Loading...
