Panasonic KX-UT113

Soft Buttons (S1 to S4)
S1
to S4 (located below the display) are used to select the item displayed on the bottom line of the display.
Message/Ringer Lamp
*1
When you receive a call or Hold Recall, the lamp flashes green.
When someone has left you a message, the lamp stays on red.
*1
If KX-UT113/KX-UT123/KX-UT133/KX-UT136
is connected to a KX-NS1000 PBX, the Message/Ringer Lamp shows the current
status as follows:
– Green flashing: You are receiving an intercom call, or you are receiving a Hold Recall or Transfer Recall from an extension.
– Red flashing: You are receiving an outside call, or you are receiving a Hold Recall or Transfer Recall from an outside line.
– Red on: You have a message.
Navigator Key
Used to adjust the volume or select desired items.
ENTER
Used to assign the selected item.
Handset Hook
Keeps
the handset stable when the unit is mounted on a wall. For details, see "To Lock the Handset Hook
when the Unit is Wall Mounted (Page 76)".
FORWARD/DO NOT DISTURB/
Used to set Call Forwarding or Do Not Disturb on your extension.
CONF (Conference)/CONFERENCE/
Used to establish a local three-way conference.
REDIAL/
Used to redial the last dialled number.
FLASH/RECALL/
Used to disconnect the current call and make another call without hanging up.
MESSAGE/
Used to access your voice mailbox.
HOLD/
Used to put a call on hold.
When a call is on hold, the Hold lamp (
KX-UT113/KX-UT123 only) flashes red.
MUTE/AUTO ANSWER/
Used to receive an incoming call in hands-free mode or mute the microphone/handset during a
conversation.
MIC
Used for hands-free conversation.
TRANSFER/
Used to transfer a call to another party.
SP-PHONE (Speakerphone)/HEADSET/
Used for performing hands-free operations. When the SP-PHONE is used, the lamp on the SP-PHONE
(KX-UT133/KX-UT136/KX-UT248 only) or the lamp above the SP-PHONE (KX-UT113/KX-UT123 only)
turns red. When muted, the lamp flashes red.
CANCEL
Used to cancel the selected item.
Flexible Buttons/Flexible Button Lamps (KX-UT133/KX-UT136/KX-UT248 only)
Used to make or receive calls, or perform the feature that has been assigned to the button. The flexible
button lamp shows the status of each flexible button. For details, see
"Flexible Buttons (KX-UT133/
KX-UT136/KX-UT248 only) (Page 39)".
Page Keys (KX-UT248 only)
Used
to switch the page of flexible buttons displayed. There are three pages of eight flexible buttons. For
details, see "Display of Assigned Flexible Buttons (KX-UT248 only) (Page 24)".
Document Version 2013-03 Operating Instructions 19
Before Operating the Telephone