42
DVQX1572 (ENG)
Recording
Controlling Focus After Recording
(Post Focus/Focus Stacking)
Applicable modes:
The camera allows you to take 4K burst pictures while shifting the focus to different
areas. After taking these pictures, you can select the desired focus area.
This function is suited for recording still objects.
• Use a UHS Speed Class 3 card.
• We recommend that you use a tripod when recording images to be used for Focus
Stacking.
1
Press [ ] (4).
2
Press 2/1 to select the Post Focus
icon ([ ]), and press [MENU/SET].
• By default, you can also perform the same
operations as steps
1 and 2 by pressing [Fn4]
and then selecting [ON].
3
Decide on the composition, and press
the shutter button halfway.
• Auto Focus will detect focus areas on the screen.
(Excluding the edges of the screen)
• If no areas on the screen can be brought into
focus, the focus display (
A
) will flash. Recording
is not possible in this case.
4
Press the shutter button fully to start
recording.
• The focus point changes automatically while
recording. When the icon (
B
) disappears,
recording automatically ends.
• A motion picture will be recorded with [Rec
Format] set to [MP4].
• When [Auto Review] is enabled, a screen that lets you select the desired focus
area will be displayed. (P43)
From the time you press the shutter button halfway until the end of recording:
• Maintain the same distance to the subject and the same composition.
DC-LX100M2PPP-DVQX1572_eng.book 42 ページ 2018年8月7日 火曜日 午後5時10分