100
Focus, Brightness (Exposure) and Colour tone Settings
Taking pictures with Exposure Compensation
Recording mode:
Corrects the exposure when there is a backlight or when the subject is too dark or too
bright.
1
Press [ ] button ( )
2
Rotate the rear dial to compensate the
exposure
Exposure Compensation
• You can change the setting content on the exposure
compensation screen from [Exposure Comp. Disp. Setting] in
the [Custom] menu. (→182)
Under-exposed
Optimum
exposure
Over-exposed
Adjust the
exposure to the [+]
direction
Adjust the
exposure to the [-]
direction
3
Press [MENU/SET] to set
• You can also press the shutter button halfway to set.
●
In Manual Exposure Mode, you can correct the exposure only when the ISO sensitivity is
set to [AUTO].
(You can select Exposure Compensation when the Quick menu is displayed by pressing
the [Q.MENU/
] button.)
●
You can set the exposure compensation value in the range between –5 EV and +5 EV.
Settings can be made within a range of –3 EV to +3 EV while recording motion pictures, recording
4K photos, or recording in [Post Focus].
●
Depending on the brightness, this may not be possible in some cases.
●
When the Exposure Compensation value is out of the –3 EV to +3 EV range, the brightness of
the recording screen will no longer change. It is recommended to record by checking the actual
brightness of the recorded image in the Auto Review or playback screen.
●
The set Exposure Compensation value is stored even if the camera is turned off. (When [Exposure
Comp. Reset] is set to [OFF])
To Next Page
Loading...
Need help?
General
