Panasonic Lumix DMC-F1 - Setting up the Power Save Mode

Technical use
73
Setting up the Power Save Mode
In this mode, if the camera is not operated for
a certain amount of time, it is automatically
turned off.
1
Press the [MENU] button.
2
Press 1 to open the setup menu .
3
Press 3/4 to select [POWER SAVE] .
4
Press 2/1 to choose the setting time.
• [2 MIN.]
• [5 MIN.]
•[10MIN.]
• [OFF]: The power is not turned off
automatically.
5
Press the [MENU] button.
• The menu will disappear.
• If you want to cancel the power save mode, turn the power switch to [ON] again after
turning it to [OFF], or press the shutter button.
• When using the AC adaptor/connecting to a PC/recording the motion image/playing back
the motion image/during slide show, the power save mode is not available.
• In simple mode [ ], the power save is fixed to [2 MIN.].
• In recording mode, when keeping the [DISPLAY] button pressed for 2 seconds, power save
mode starts.
1,5 2,3,4
SETUP 1/2
SELECT SET EXIT
MENU
REC
MONITOR
POWER SAVE
2 MIN. 5 MIN. 10 MIN.
AUTO REVIEW
BEEP
1
3,4
KC42‑PP.book73ページ２００２年１２月１９日 木曜日 午後４時３６分