20
Basic Operation
SQT0628 (ENG)
Taking a Still picture
• Set the drive mode dial to [ ] (single recording).
1
Select the Recording Mode. (P19)
2
Press the shutter button halfway to focus.
A Aperture value
B Shutter speed
• Aperture value and shutter speed are displayed.
(It will flash in red if the correct exposure is not
achieved, except when set to flash.)
3
Press the shutter button fully (push it in further), and take the
picture.
Recording Motion Picture
This camera can record full high definition motion pictures compatible with the AVCHD format
or motion pictures recorded in MP4.
• You can operate the zoom even when recording motion pictures.
• If the Extra Optical Zoom is used before pressing the motion picture button, those settings will be
cleared, so the shooting range will change dramatically.
• Confirm the settings for the O.I.S. switch and the manual ring selector switch before recording a
motion picture. Be careful not to accidentally switch them during recording.
•
Still picture recording is also possible during the motion picture recording by fully pressing the shutter button.
1
Start recording by pressing the motion picture button.
•
Release the motion picture button right after you press it.
• The operational sound of the zoom or button operation may
be recorded when it is operated during the recording of a
motion picture.
2
Stop the recording by pressing the motion
picture button again.
A Elapsed recording time
B Available recording time
Focus When the subject is focused
When the subject is not
focused
Focus indication
On Blinks
AF area
Green —
Sound
Beeps 2 times Beeps 4 times
DMC-FZ1000_GA_eng.book 20 ページ ２０１４年８月１９日 火曜日 午後７時１９分
To Next Page
Loading...
