54
Using the Wi-Fi function
SQT0628 (ENG)
Wi-Fi
R
function/NFC function
∫ Describing method
When you see a step that says, “Select [Select a destination from History].” or a similar step,
press the cursor buttons to select [Select a destination from History], and press [MENU/SET].
∫ About the Wi-Fi connection lamp
∫ About the [Wi-Fi] button
Pressing and holding [Wi-Fi] before connecting to Wi-Fi
(When connecting to a smartphone)
•
The information required for connecting the smartphone to this
unit (QR code, SSID and password) is displayed.
Pressing [Wi-Fi] before connecting to Wi-Fi
•
Following items can be selected.
• These operating instructions describes the procedure for [New Connection].
What you can do with the [Wi-Fi] button when connected to Wi-Fi
•
Following items can be selected.
¢ This is not displayed when the destination of [Remote Shooting & View], [Playback on TV] or
[Send Images Stored in the Camera] is set to [Printer].
• We strongly recommend that you set an encryption to maintain information security.
• When sending images on a mobile network, high packet communication fees may be incurred
depending on the details of your contract.
Lit blue: The Wi-Fi connection is on standby
Blinking blue:
Sending/receiving data through the Wi-Fi connection
[Wi-Fi]/[Fn2] button can be used in two ways, as [Wi-Fi] or
as [Fn2] (function 2).
At the time of purchase, it is initially set to [Wi-Fi].
[New Connection]
[Select a destination from History]
[Select a destination from Favorite]
[Terminate the Connection]
[Change the Destination]
[Change Settings for Sending Images]
¢
[Register the Current Destination to Favorite]
[Network Address]
DMC-FZ1000_GA_eng.book 54 ページ ２０１４年８月１９日 火曜日 午後７時１９分
To Next Page
Loading...
