9. Stabilizer, Zoom and Flash
210
[Wireless Setup]
•
Press the [DISP.] button to fire a test-flash.
A Firing Mode
B Flash output
C Luminosity ratio
¢ When the flash (DMW-FL360L, DMW-FL580L:
optional) is attached, [External Flash] is
displayed instead of [Built-in Flash].
[Built-in
Flash]
¢
[Firing Mode]
[TTL]: The camera automatically sets the output of the built-in flash.
[OFF]: The built-in flash fires only a signal-flash.
[Flash Adjust.]
The output of the built-in flash is set manually.
[External
Flash]
¢
[Firing Mode]
[TTL]: The camera automatically sets the output of the external flash.
[AUTO]: Flash output is set by the external flash.
[MANUAL]: Set the luminosity ratio of the external flash manually.
[OFF]: The external flash fires only a signal-flash.
[Flash Adjust.]
Set the output of the external flash manually when [Firing Mode] is set to
[TTL].
[Manual Flash Adjust.]
Set the luminosity ratio of the external flash when [Firing Mode] is set to
[MANUAL].
• You can set from [1/1] (full brightness) to [1/128] in steps of 1/3.
[A Group]/
[B Group]/
[C Group]
[Firing Mode]
[TTL]: The camera automatically sets the output of the external flash.
[AUTO]: Flash output is set by the external flash.
[MANUAL]: Set the luminosity ratio of the external flash manually.
[OFF]: The external flashes in the specified group will not fire.
[Flash Adjust.]
Set the output of the external flash manually when [Firing Mode] is set to
[TTL].
[Manual Flash Adjust.]
Set the luminosity ratio of the external flash when [Firing Mode] is set to
[MANUAL].
• You can set from [1/1] (full brightness) to [1/128] in steps of 1/3.
To Next Page
Loading...
