12. Using the Wi-Fi function
256
If you are using an iOS device
When scanning the QR code to set up a connection
(If you are reconnecting the camera, steps 1 to 5 are not required)
1 Start “Image App”. (P254)
2 Select [QR code], and then select [OK].
3 Using “Image App”, scan the QR code displayed
on the screen of the camera.
•
If you press [MENU/SET] on the camera, the QR
code will be enlarged. When it is difficult to scan
the QR code, try enlarging it.
(If the scanning is not successful, move the
camera and the smartphone further away from
each other and try again or use a connection method other than the QR code
method.)
4 Install the profile of “IMAGE APP”.
•
A message will be displayed on the browser.
• If the smartphone is locked with a passcode, enter the
passcode to unlock the smartphone.
5 Press the home button to close the browser.
6 Turn on the Wi-Fi function in the setting menu of the smartphone.
7 Select the SSID displayed on the screen of the
camera.
8 Return to the home screen, and then start “Image
App”. (P254)
IMAGE APP
Panasonic Corporation
To Next Page
Loading...
