267
12. Using the Wi-Fi function
1 Select the menu.
2 Select [Via Network] or [Direct], and connect. (P288)
3 Select a device you want to connect.
•
When the connection is complete, the screen is displayed. To change the send setting,
press [DISP.]. (P296)
4 Select [Single Select] or [Multi Select].
•
To change the setting or disconnect, press [Wi-Fi]. (P252)
Sending selected images ([Send Images Stored in the Camera])
> [New Connection] > [Send Images Stored in the Camera] >
[Smartphone]
On your smartphone
When connecting with [Via Network]:
1 Turn on the Wi-Fi function.
2 Select the wireless access point you want to connect to, and set.
3 Start “Image App”. (P254)
When connecting with [Wi-Fi Direct] or [WPS Connection] in [Direct]:
1 Start “Image App”. (P254)
When connecting with [Manual Connection] in [Direct]:
1 Turn on the Wi-Fi function.
2 Select the SSID that matches the one displayed on the screen of this unit, and
then enter the password.
3 Start “Image App”. (P254)
[Single Select] setting
1 Select the picture.
2 Press [MENU/SET].
[Multi Select] setting
1 Select the picture. (repeat)
•
The setting is canceled when the picture is selected
again.
2 Select [OK].
•
The number of pictures that can be sent by [Multi
Select] is limited.
• Confirmation screen is displayed. It is executed when [Yes] is selected.
2.
To Next Page
Loading...
