12. Using the Wi-Fi function
282
1 Select the menu.
2 Select [Via Network], and connect. (P288)
3 Check the send setting.
•
When the connection is complete, the screen is displayed. To change the send setting,
press [DISP.]. (P296)
4 Take pictures.
•
To change the setting or disconnect, press [Wi-Fi]. (P252)
You cannot change the settings while sending pictures. Wait until sending is complete.
1 Select the menu.
2 Select [Via Network], and connect. (P288)
3 Check the send setting.
•
When the connection is complete, the screen is displayed. To change the send setting,
press [DISP.]. (P296)
4 Select [Single Select] or [Multi Select].
•
To change the setting or disconnect, press [Wi-Fi]. (P252)
Sending an image each time a recording is made ([Send Images While
Recording])
> [New Connection] > [Send Images While Recording] > [Cloud
Sync. Service]
Sending selected images ([Send Images Stored in the Camera])
> [New Connection] > [Send Images Stored in the Camera] >
[Cloud Sync. Service]
[Single Select] setting
1 Select the picture.
2 Press [MENU/SET].
[Multi Select] setting
1 Select the picture. (repeat)
•
The setting is canceled when the picture is selected
again.
2 Select [OK].
•
The number of pictures that can be sent by [Multi
Select] is limited.
• Confirmation screen is displayed. It is executed when [Yes] is selected.
To Next Page
Loading...
