177
6. Shutter and Drive Settings
• We recommend using the shutter remote control (DMW-RSL1: optional) when you want to
keep the shutter button pressed fully while taking pictures in Burst Mode. Refer to P354 for
information about the shutter remote control.
• When the burst speed is set to [SH] or [H] (when focus mode is [AFS] or [MF]), the exposure
and White Balance are fixed at the settings used for the first picture for the subsequent pictures
as well.
When the burst speed is set to [H] (when focus mode is [AFF] or [AFC]), [M] or [L], they are
adjusted each time you take a picture.
• Since the shutter speed becomes slower in dark places, the burst speed (pictures/second) may
become slower.
• Depending on the operating conditions, it may take time to take the next picture if you repeat
the recording of pictures.
• It may take time to save pictures taken in Burst Mode on the card. If you take pictures
continuously while saving, the maximum number of recordable pictures decreases. For
continuous shooting, use of a high speed memory card is recommended.
Not available in these cases:
•
The Burst Mode is disabled in the following cases.
– [Rough Monochrome]/[Silky Monochrome]/[Miniature Effect]/[Soft Focus]/[Star Filter]/
[Sunshine] (Creative Control Mode)
– When White Balance Bracket is set
– When recording motion pictures
– When recording using the flash
– When recording with the shutter speed set to [B] (Bulb)
– When recording with [iHandheld Night Shot]
– When [HDR] is set to [ON]
– When using [Multi Exp.]
– When using [Time Lapse Shot]
– When using [Stop Motion Animation] (only when [Auto Shooting] is set)
– When [Simultaneous record w/o filter] of [Filter Settings] is set to [ON]
• In the following cases, [SH] in Burst Mode cannot be used.
– When [Quality] is set to [ ], [ ] or [ ]
– When using [Stop Motion Animation]
– When using [Shutter Delay]
To Next Page
Loading...
Need help?
General
Weight and Dimensions
