6. Shutter and Drive Settings
194
∫ Changing the settings for [Single/Burst Settings], [Step] and [Sequence] in Auto
Bracket
1 Select the menu. (P63)
2 Press 3/4 to select [Single/Burst Settings], [Step] or [Sequence] and then
press [MENU/SET].
3 Press 3/4 to select the setting and then press [MENU/SET].
•
You can take one picture at a time when set to [ ].
• You can continuously take pictures up to set numbers when set to [ ].
• Exit the menu after it is set.
• When taking pictures using Auto Bracket after setting the Exposure Compensation value, the
pictures taken are based on the selected Exposure Compensation value.
Not available in these cases:
•
Auto Bracket is disabled in the following cases.
– [Rough Monochrome]/[Silky Monochrome]/[Miniature Effect]/[Soft Focus]/[Star Filter]/
[Sunshine] (Creative Control Mode)
– When White Balance Bracket is set
– When recording motion pictures
– When recording using the flash
– When recording with the shutter speed set to [B] (Bulb)
– When recording with [iHandheld Night Shot]
– When [HDR] is set to [ON]
– When using [Multi Exp.]
– When using [Time Lapse Shot]
– When using [Stop Motion Animation] (only when [Auto Shooting] is set)
– When [Simultaneous record w/o filter] of [Filter Settings] is set to [ON]
> [Rec] > [Auto Bracket]
[Single/Burst Settings]
[ ] (single)
[ ] (burst)
[Step]
[3•1/3] (3 pictures)
[3•2/3] (3 pictures)
[3•1] (3 pictures)
[5•1/3] (5 pictures)
[5•2/3] (5 pictures)
[5•1] (5 pictures)
[7•1/3] (7 pictures)
[7•2/3] (7 pictures)
[7•1] (7 pictures)
[Sequence]
[0/`/_]
[`/0/_]
MENU
To Next Page
Loading...
