11. Using the Wi-Fi/NFC Function
308
A picture can be automatically sent to a specified device every time you take it.
•
When connected with [Send Images While Recording], [ ] is
displayed on the recording screen, and [ ] is displayed while
sending a file.
• To terminate the connection, follow the steps below:
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [Yes]
• You can terminate the connection or change the send settings
by pressing [Wi-Fi]. (P287)
You cannot change the settings while sending pictures. Wait until sending is complete.
• Since the camera gives priority to recording, sending may take longer during the recording.
• If you turn off this unit or the Wi-Fi connection before sending is complete, unsent pictures will
not be resent.
• You may not be able to delete files or use the playback menu while sending.
Not available in these cases:
•
You cannot send motion pictures and 4K burst files.
Images can be selected and sent after recording.
∫ How to select an image(s) after selecting [Single] or [Multi]
•
Details of the playback menu [Favorite] or [Print Set] settings will not be sent.
Not available in these cases:
•
Some images taken with a different camera may not be able to be sent.
• Images that have been modified or edited with a computer may not be able to be sent.
Send Images While Recording
Send Images Stored in the Camera
[Single Select] setting
1 Select the picture.
2 Select [Set].
[Multi Select] setting
1 Select the picture. (repeat)
•
The setting is canceled when the picture is selected
again.
2 Select [OK].
•
The number of pictures that can be sent by [Multi Select]
is limited.
• Confirmation screen is displayed. It is executed when [Yes] is selected.
• To change the send settings on a screen that is displayed after the image has been sent,
press [DISP.]. To terminate the connection, select [Exit].
To Next Page
Loading...
