- 71 -
Advanced (Recording pictures)
∫ Adjust the flash output
Adjust the flash output when the subject is small, or the reflectivity is very high or low.
1 Select [FLASH ADJUST.] from the [REC] Mode menu, and
then press 1. (P28)
2 Press 2/1 to set the flash output and then press [MENU/
SET].
•
You can adjust from [j2 EV] to [i2 EV] in steps of [1/3 EV].
• Select [0 EV] to return to the original flash output.
3 Press [MENU/SET] to close the menu.
•
You can also close the menu by pressing the shutter button halfway.
Note
•
When the flash output is adjusted, the flash output value appears on the upper left of the
screen.
• The flash output setting is memorized even if the camera is turned off.
• You cannot set [FLASH ADJUST.] in the following cases.
– In Intelligent Auto Mode
– In [FLASH BURST] in Scene Mode
To Next Page
Loading...
