Connecting to other equipment
Connecting to a PictBridge-compliant Printer
$;:S~i:l'Z~~~~~\ic~~~~~~
-'''';m~~
By connecting the camera directly to a
printer supporting PictBridge via the USB
connection cable (supplied), you can select
the pictures to be printed or start printing
on
the LCD monitor. Make the necessary
settings on your printer beforehand. (Read
your printer's operating instructions.)
1 Turn
on
the camera
and
the printer.
2 Connect the camera to a printer
via the USB connection cable
®
(supplied).
• The screen to select [PictBridge (PTP)]
or [PC] is displayed.
• If [USB MODE] in setup menu is set to
other than [SELECT ON CONNECTION],
the screen is not displayed (P23).
AVOUT
~®
~rn
~
DIGITAL
® USB connection cable (supplied)
• Connect the USB connection cable
with the [
~]
mark facing the
[~]
mark on the [DIGITAL] socket.
® AC adaptor (DMW-AC6PP: optional)
© DC coupler (DMW-DCC2: optional)
• Use batteries with sufficient battery
power
or
the AC adaptor ® and the
DC coupler
©.
• Always use a genuine Panasonic AC
adaptor (DMW-AC6PP: optional) and
DC coupler (DMW-DCC2: optional).
•
Make
sure
the
camera
is
off
before
connecting
or
disconnecting
the
AC
adaptor.
® Check the facing of the connector and
push straight in.
• Hold ® and then insert or pull the USB
connection cable straight.
Do
not try
to force the connector
in
backwards or
sideways. This can damage this unit and
the equipment you are connecting.
3 Select [PictBridge]
using'"
and
press [MENU/SET].
g
..
".
• Do not use any other USB connection
cables except the supplied one.
• If a card is not inserted when the camera
is connected to the printer, you can print
the picture data on the built-in memory.
If a card is inserted, you can print the
picture data on
it.
• You cannot switch between the built-in
memory and the card while the camera
is connected to the printer. When you
want to switch between the built-in
memory and the card, disconnect the
USB connection cable, insert (or remove)
the card and then connect the USB
connection cable to the printer again.
• To print the name or the age
in
[BABY] and [PET]
in
scene mode, the
departure date for [TRAVEL DATE] or
the text input
in
[TITLE EDIT], use the
[PHOTOfunSTUDIO-viewer-] software
in
the CD-ROM (supplied) and print from
the PC. For information about this, refer
to the separate operating instructions
(PDF file) of the software.
• To find out more about PictBridge
compliant printers, contact your local
dealer.
103
To Next Page
Loading...
