VQT1Z82 101
Copying still pictures and motion pictures
Set-up:
• Use a fully charged battery, or connect the AC adaptor (DMW-AC5PP, sold separately)
and Multi Conversion Adaptor (DMW-MCA1, sold separately). (P.103)
• Card : Insert card and set mode dial to any except
Built-in memory: Remove card
To cancel connection Click ‘Safely Remove Hardware’ in the Windows
System Tray disconnect USB connection cable
turn off camera power disconnect AC adaptor
Turn on power of both
camera and computer
Connect camera to
computer
Please make sure you use the
supplied USB connection cable.
Use of cables other than the supplied
USB connection cable may cause
malfunction.
Select ‘PC’ on the camera
A message may be displayed on screen
if ‘USB MODE’ (P.24) is set to ‘PictBridge
(PTP)’. Select ‘CANCEL’ to close the
screen, and set ‘USB MODE’ to ‘PC’.
Operate with your
computer
Check socket direction and insert straight in.
(Damage to socket shape can lead to faulty operation.)
ACCESS (sending data)
• Do not disconnect the USB connection
cable while ‘ACCESS’ is displayed.
USB connection cable
(always use cable supplied)
Some computers can read directly from the camera’s memory card.
For details, see the manual for your computer.
To Next Page
Loading...
Need help?
General
