80 VQT1Z82
Using REC/MOTION PICTURE menu
(Continued)
REC/PLAY switch: See P.18 for menu setting procedure.
REC QUALITY
Sets the picture quality of the motion picture that is recorded.
MODE: MOTION PICTURE menu
REC menu
Settings:
‘AVCHD Lite’ in REC MODE
Setting Resolution Bit rate
1
Aspect ratio
SH 1280 x 720 17 Mbps
16:9H 1280 x 720 13 Mbps
L 1280 x 720 9 Mbps
‘MOTION JPEG’ in REC MODE /
Setting Resolution Frame rate
2
Aspect ratio
HD
1280 x 720 30 fps
16:9
WVGA 848 x 480 30 fps
VGA 640 x 480 30 fps
4:3
QVGA 320 x 240 30 fps
1
The bit rate is the amount of data per unit time. A higher value translates into a higher image
quality. This camera uses the VBR (Variable Bit Rate) recording system and the available recording
time is shorter when recording a subject with rapid movements.
2
The frame rate is the number of frames per second.
‘WVGA’ cannot be set in INTELLIGENT AUTO Mode.
‘QVGA’ only can be recorded to the built-in memory.
CONTINUOUS AF
Either allow the focus to be constantly adjusted during motion picture recording, or fix the
focus position at the start of recording.
MODE: MOTION PICTURE menu
REC menu
Settings: ON: Adjust focus according to movement of subject during motion
picture recording.
( appears on the screen.)
OFF: Fix focus position at the start of motion picture recording.
Use this setting to keep the same focus position for subjects with little
forward/backward movement.
WIND CUT
Reduces recording of wind sounds (wind noise) when recording in a strong wind
MODE: MOTION PICTURE menu
Settings: OFF/ON ( appears on the screen.)
When WIND CUT is set to ‘ON’, lower sounds will be eliminated and the sound quality
will differ from that of normal recordings.
WIND CUT is not available in the DMC-ZS1.
To Next Page
Loading...
Need help?
General
