22 VQT1Z82
Using SETUP menu
(Continued)
LCD MODE
Make LCD monitor easier
to see.
OFF: Normal (cancel setting)
AUTO POWER LCD:
The brightness is adjusted automatically depending on
how bright it is around the camera.
POWER LCD:
Makes screen brighter than normal (for outdoor use).
HIGH ANGLE:
Makes screen easier to see when taking pictures from
high positions. (becomes harder to see from the front)
• ‘HIGH ANGLE’ will be canceled when power is turned off
(including POWER SAVE).
•
Block out sunlight (with hand, etc.) if reflection makes screen difficult to see.
•
‘AUTO POWER LCD’ or ‘HIGH ANGLE’ cannot be used in the following cases.
During playback mode or menu screen display, or when
connected to computer/printer.
•
‘POWER LCD’ will be deactivated if no operations are performed for 30
seconds while recording. (Brightness can be restored by pressing any button)
•
Brightness/color of screen in ‘LCD MODE’ has no effect on pictures recorded.
• ‘AUTO POWER LCD’ cannot be set in playback mode.
• The number of recordable pictures and the recording time are
reduced when using ‘AUTO POWER LCD’ or ‘POWER LCD’.
DISPLAY SIZE
Change the display size
of the menu.
STANDARD/LARGE
GUIDE LINE
Select recording
information display and
types of guidelines.
(P.42)
REC. INFO.
OFF/ON (Display recording information with guide lines.)
PATTERN
/ : Change the patterns of guide lines.
HISTOGRAM
Check subject brightness
on graph. (P.42)
OFF/ON
REC AREA
Enables verification of
the recordable area for
a motion picture before
recording.
OFF/ON
This section is not
recorded.
• Recordable area displayed for motion
pictures should be interpreted as a
guideline.
• When using extended optical zoom,
the recordable area may not always be
displayed for certain zoom ratios.
• This setting cannot be used with Intelligent
Auto Mode.
Item Settings, notes
The ‘REC AREA’ menu item is not available in the DMC-ZS1.
To Next Page
Loading...
