VQT1Z82 111
Other related operations
Power OFF
The camera’s power can also be switched off when switching the television’s power
off with the remote control.
Automatic input select
• This function automatically switches the television input to the camera screen
whenever the camera’s power is switched on while it is connected via the HDMI mini
cable. The television can also be switched on via the camera from standby mode (if
‘Power on link’ on the television is set to ‘ON’).
• The input setting may not be able to be changed automatically with certain television
HDMI sockets. In this case, please change the input setting with your television’s
remote control (consult your television’s operating instructions for details).
• Refer to P.120 if VIERA Link (HDMI) does not function correctly.
If you are unsure whether or not the TV you are using are compatible with VIERA Link,
read the operating instructions for the devices.
If the ‘VIERA Link’ setting on the camera (P.26) is ‘ON’, operations via the camera
buttons will be limited.
Ensure that the television you are connecting to has been set up to enable VIERA Link
(HDMI) (consult your television’s operating instructions for details).
If you do not wish to use VIERA Link (HDMI), turn the camera’s ‘VIERA Link’ setting
(P.26) ‘OFF’.
‘HDMI MODE’ (P.25) ‘1080i’ is only effective in the following cases:
• The
tab on the TV screen is selected
• SLIDESHOW ‘PICTURE ONLY’ is selected
• SLIDESHOW ‘CATEGORY SELECTION’ is selected (except for
Travel date)
In all other cases, images will be outputted as ‘720p’.
If the tab on the TV screen is selected while ‘HDMI MODE’ (P.25) is set to ‘AUTO’ or
‘1080i’, the screen will go back before the single picture playback display resumes. This
is not a fault.
If the tab on the TV screen is selected, it will not be possible to select either
(Travel date), (AVCHD Lite), or (MOTION JPEG) in SLIDESHOW ‘CATEGORY
SELECTION’.
To Next Page
Loading...
Need help?
General
