- 142 -
Wi-Fi
To transfer images automatically ([Smart Transfer])
Smart Transfer is a function that automatically transfers images in the camera to a PC.
The transfer starts when you connect the camera to the AC adaptor (supplied).
•
When [Auto Transfer] is set to [ON], the camera automatically uploads recorded images. For this
reason images may be uploaded unintentionally if, for example, you share this unit with other
people.
Panasonic assumes no responsibility for any damages caused by uploaded images.
• Panasonic assumes no responsibility for any damages caused by the use of [Smart Transfer].
• When you bring the camera on an airplane or to a hospital, etc., set [Airplane Mode] to [ON], and
turn off the camera because electromagnetic waves, etc. emitted by the camera may interfere with
gauges. (P45)
• When a charging error occurs, Smart Transfer may not be performed. (P170)
• Smart transfer is not available for images stored in the built-in memory.
• [Smart Transfer] is not available when the memory card is locked.
Example of [Auto Transfer]
A AC adaptor (supplied)
B USB connection cable (supplied)
C PC
1 Set [Auto Transfer] to [ON]
2 Record
3 Charge
4 Start a transfer
To perform Smart Transfer, follow the steps below:
1 Set up Smart Transfer (initial setup). (P143)
2 Perform [Auto Transfer]. (P143)
To Next Page
Loading...
Need help?
General
