Panasonic Lumix S9

Video Settings – Main Assist Functions
387
 []  []  Select [Zebra Pattern]
 When [BASE/RANGE] Was Selected with [SET]
Centered on the brightness set with [Base Level], parts with the brightness
in the range set in [Range] are displayed with the stripes.
≥ [Base Level] can be set in the range between 0 % and 109 % (IRE).
≥ [Range] can be set in the range between ±1 % and ±10 % (IRE).
•
When [Photo Style] is set to [V-Log], or when a LUT file has not been applied in
[REAL TIME LUT] (base Photo Style is [V-Log]), this is measured with “Stop” units.
(18 % gray output level is calculated as 0 Stop)
[ZEBRA1]
Parts that are brighter than the base value are displayed with
[ZEBRA1] stripes.
[ZEBRA2]
Parts that are brighter than the base value are displayed with
[ZEBRA2] stripes.
[ZEBRA1+2] Both [ZEBRA1] and [ZEBRA2] are displayed.
[OFF] —
[SET]
Sets the base brightness.
[Zebra 1] [50%] to [105%]/[BASE/RANGE]
[Zebra 2] [50%] to [105%]/[BASE/RANGE]
• [ZEBRA1+2] cannot be selected while you are setting [BASE/RANGE].