Connecting to Other Devices – Storing on a Recorder
667
Storing on a Recorder
By connecting the camera to a Panasonic Blu-ray disc recorder or DVD
recorder, you can store the pictures and videos.
Getting started:
•
Turn on the camera and recorder.
1
Connect the camera and recorder with the USB
connection cable (commercially available). (USB port:
657)
2
Press 34 to select [PC(Storage)] and then press .
3
Operate the recorder to store the images.
•
If [USB Mode] is set to [PC(Storage)] in the [Setup] ([IN/OUT]) menu, the camera
will be automatically connected to the recorder without the [USB Mode] selection
screen being displayed. ([USB Mode]: 563)
•
Take care not to turn off the camera while storage is in progress.
•
Images such as 4K videos may not be supported depending on your recorder.
•
Turn off the camera and disconnect the USB connection cable before removing
the card from the camera. Otherwise, the recorded data may be damaged.
•
For the storage and playback procedures, refer to the operating instructions for
the recorder.
To Next Page
Loading...
