Connecting to Other Devices – Tethered Recording
670
Operating the Camera from a PC
Getting started:
•
Turn on the camera and PC.
•
Install “LUMIX Tether ” on PC.
1
Connect the camera and PC with the USB connection
cable (commercially available). (USB port: 657)
2
Press 34 to select [PC(Tether)] and then press .
≥[ ] is displayed on the camera’s screen.
3
Use “LUMIX Tether” to operate the camera from the PC.
•
If [USB Mode] is set to [PC(Tether)] in the [Setup] ([IN/OUT]) menu, the camera
will be automatically connected to the PC without the [USB Mode] selection
screen being displayed. ([USB Mode]: 563)
•
The Wi-Fi/Bluetooth functions are not available while there is a PC connection
with [PC(Tether)].
To Next Page
Loading...
