Getting Started – Charging the Battery
49
•
To recover from [Sleep Mode] or [Sleep Mode(Wi-Fi)], perform one of the following
operations:
– Press the shutter button halfway.
– Set the camera on/off switch to [OFF] and then [ON] again.
•
To recover from [Auto Monitor Off], press any button.
[Sleep Mode] Sets the amount of time until the camera is put to sleep.
[Sleep
Mode(Wi-Fi)]
Sets the camera to sleep 15 minutes after being disconnected
from Wi-Fi.
[Auto Monitor
Off]
Sets the amount of time it takes for the monitor to turn off.
(The camera is not turned off.)
To Next Page
Loading...
