Panasonic Lumix S9

Wi-Fi / Bluetooth – Using “LUMIX Lab”
601
 To Stop the Automatic Transfer of Images
 []  []  [Bluetooth]  [Auto Transfer]  Select [OFF]
≥ A confirmation screen is displayed, asking you to terminate the Wi-Fi
connection.
•
If the [Bluetooth Function] and [Auto Transfer] settings of the camera are [ON],
the camera automatically connects to the smartphone via Wi-Fi and Bluetooth
when you turn on the camera.
Start up the “LUMIX Lab” on the smartphone to connect to the camera. Note that
if “LUMIX Sync ” is running on the smartphone, automatic image transfer may not
work properly.
• When [Auto Transfer] is set to [ON], [Wi-Fi Function] cannot be used.
• Automatic image transfer is interrupted while recording or playing back videos.
The transfer starts at the start of the file where it was interrupted when the
transmission restarts.
• If the camera is turned off during image transfer, and the file sending is
interrupted, then turn on the camera to restart the sending.
– If the storage status of unsent files changes, then sending of files may no
longer be possible.
– If there are many unsent files, then sending of all files may not be possible.
• If automatic image transfer is performed in places where the ambient
temperature is high, communications may be interrupted.
The camera automatically reconnects when its temperature goes down and
automatic image transfer restarts.
If automatic image transfer does not restart, turn the camera off then on again to
reconnect.
• Images recorded with the following function cannot be transferred automatically:
– [MP4]/[MOV] ([Rec. File Format])