Wi-Fi / Bluetooth – [Wi-Fi Setup] Menu
654
[PC Connection]
You can set the workgroup.
To send images to a PC, you need to connect to the same workgroup as the
destination PC.
(The default setting is “WORKGROUP”.)
•
To change the workgroup name, press and enter the new workgroup name.
How to enter characters (Entering Characters: 90)
•
To return to the default settings, press [DISP.].
[Device Name/Password]
You can change the camera name (SSID) and password.
•
Press [DISP.] to change the device name and password.
How to enter characters (Entering Characters: 90)
•
The number of characters you can enter is a maximum of 32 for the device name
and between 8 and 63 for the password.
[Wi-Fi Function Lock]
To prevent incorrect operation and use of the Wi-Fi function by a third party and to
protect personal information in the camera and included with images, protect the Wi-Fi
function with a password.
[Setup]: Enter any 4-digit numbers as the password.
•
How to enter characters (Entering Characters: 90)
[Cancel]: Cancel the password.
•
Once a password is set, you are required to enter it each time you use the Wi-Fi
function.
•
If you forget your password, you can use [Reset] in the [Setup] ([Setting]) menu to
reset the network settings and thereby reset the password.
[Network Address]
Displays the MAC address and IP address of the camera.
•
When the following function is being used, [Network Address] is not available:
– Tethered recording
To Next Page
Loading...
Need help?
General
